HTC Touch Diamond2 HardSPL

1)      download newest Hard-SPL package from Topaz-HardSPL_V5_00R5.zip attachment, extract to an empty folder.
2) you must Have Phone Synced with PC in Windows Mobile!!! and it must not be in Flight mode (i.e. radio should be on).
3) NEW: internet access is required as the program checks online for updates and license.
4) run Topaz-HardSPL_V5_00R5.exe on PC, make sure it's launched from a local drive (not through network drive, etc.). XP requires Admin logon, and Vista/Windows 7 will automatically prompt to allow it to run in Admin mode, allow it please. if the exe fails to run or throws an exception (i.e. crashes), report this in the thread with exact error message/code. if you get an antivirus warning, please ignore it, it contains no harmful code (just used a packer to compress it).
5) follow steps as prompted in the Hard-SPL program. if this is the first run of Hard-SPL on a device after hard reset, you must select Automatic flash mode (the first button in Welcome screen).
notes: you should usually go for Automatic flash mode; the Manual flash option is only to be used as noted below (in NOTE 3 and in troubleshooting section) and you must only attempt the Manual mode if Automatic flash mode or SSPL-Manual.exe already put device in tricolour screen. any other errors triggered while running in Autoflash mode will have to be fixed as instructed in the error message.
6) it will ask you to wait while it prepares for the flashing, press OK.
7) now it should go through without any error messages, if one does pop up, then please follow the instructions included in the error text. if no specific instruction is shown, then ask for help in the thread, but this should not ever occur (as this means a really fatal error occurred).
8) at this point the device did hopefully went to tricolour screen reporting version as 5.01.C-SSPL, this is the SSPL version, which is temporary. then RUU will instantly launch.
9) some notes: when RUU says it will hard reset, do not worry, it is not going to do that. also when it says the flash will take 10 minutes, ignore that, it will only take a minute or so.
10) SPL flashes, device automatically reboots, job done.
11) to confirm you got it installed, go into bootloader mode (tricolour screen!) and verify the screen shows 1.83.OliNex, which is the Hard-SPL version.

-the last release (V5.00) added:
1. new HardSPL binary, 1.83.OliNex, should be fully compatible with HTC's WM6.5 RUU's.
2. new SSPL binary, supporting more devices
3. fixes; this version will also tell you in future if you need an update for HardSPL.

-previous release (V3.01) fixed the following 2 issues:
1. if you get this error message: "Please make sure the device is still plugged in and synchronized to the PC"
2. if the SPL version did not change to 1.33.OliNex, but stays on 1.33.0000